5 EZ Steps to Apply

  1. Lay out the roll flat with weight at each end for 24 hours to let it adjust. Then Clean the surface on which you want to apply the film on. Make sure the surface is smooth, clean, and dry before application. 

  2. Measure the size of the surface to where you are going to apply the film. Then cut the right size of the film, adding a couple of inches for leeway. 

  3. Peel off the backing and align the film with where you want to apply it. Then start slowly peeling off the backing.

  4. Use the squeegee provided and apply pressure evenly from the center to the edges to remove any air bubbles.

  5. Trim off the excess film if there is any left, and then enjoy your new DIY project!